SHEAR BEHAVIOR OF SELF-COMPACTING CONCRETE BEAMS REINFORCED WITH B500WR AND STRENGTHENED WITH CFRP

Document Type : Original Article

Authors

1 October High Institute For Engineering & Technology, OHI, 6th of October, Giza,, Egypt

2 Housing and Building National Research Center, HBRC, Egypt

Abstract

Fiber Reinforced Polymer (FRP) has become increasingly attractive due to its advantageous low weight, high stiffness and strength-to-weight ratio, corrosion resistance, lower maintenance costs, and faster installation time. Experimental and numerical studies researches show that using (FRP) materials to strengthen reinforced concrete (RC) beams in shear is an effective method. The purpose of this paper is to study the effect of strengthening self-compacting concrete beams using carbon fiber-reinforced polymer (CFRP) fabrics with different wrapping schemes in shear. Five rectangular beams of a rectangular cross section of 100×250 mm and a length of 1650 mm were cast and tested under four-point bending. One beam was used as a control beam without external strengthening, while the other four beams were strengthened in shear using U-Wrapped CFRP with different widths and densities. The used CFRP led to an increase in the load-carrying capacity, failure load, displacement ductility ratio, and displacement ductility index, but energy ductility was decreased. The investigation results are presented in terms of ultimate load, deflection, tensile and compressive strains, and cracking pattern
 
أصبح أستخدام البوليمرات المدعمه باأللياف منتشرا بشکل متزايد نظ ًرا للمميزات العديده التي منها الوزن المنخفض وصالبته العالية ونسبة القوة إلى الوزن ، ومقاومة التآکل ، وانخفاض تکاليف الصيانة ، والسرعه في التنفيذ مما يوفر الوقت.وقد أظهرت الدراسات المعمليه والتحليليه أن استخدام الياف الکربون في لتقوية الکمرات الخرسانية المسلحة في القص هو طريقة فعالة.ولذلک فإن الغرض من هذا البحث هو دراسة تأثير تقوية الکمرات الخرسانية ذاتية الدمک باستخدام ألواح البوليمر المقوى بألياف الکربون مع طرق مختلفه لتدعيم الکمرات واختبارها في القص. تم صب خمس کمرات مستطيلة ذات ابعاد 100 × 250 مم وطول 1650 مم واختبارها في االنحناء عند أربع نقاط وقد کانت الکمرة المرجعيه بدون تدعيم. بينما تم تقوية الکمرات األربعة األخرى في القص باستخدام الياف الکربون )شکل ᴜ )بعده طرق وکثافات مختلفه. تم عرض نتائج االختبارات من حيث الحمل النهائي ، واالنحراف ، والشد ، واالنضغاط ، ونمط التکسير.

Keywords

Main Subjects